...

Send us a Message

We're always here for you, tell us how can we help?

Laser cutting machine limit switch failure

Symptoms

  • The axis cannot move to the limit position, and the system pops up a limit alarm.
  • No alarm is triggered even when the machine runs to the extreme position.
  • The equipment stops suddenly during operation randomly, showing intermittent limit signal abnormality.
  • After triggering the limit, the axis cannot be released and returned normally.

 

 

Possible Causes

  • The limit switch is impacted, displaced or loose after long-term operation.
  • Dust, cutting slag and oil stain cover the switch contact, resulting in poor contact.
  • The internal spring or reed of the switch is fatigued and fails to reset.
  • Signal cable is worn, broken or the connector is loose and oxidized.
  • The PLC input terminal or control board signal channel is damaged.
  • The switch wiring definition is wrong, normally open and normally closed signal are mixed.

 

 

Solutions

  • Power off the machine first, check the installation position and fastening status of the limit switch, and re-fix and calibrate if it is offset.
  • Clean the surface of the switch and contact points with clean compressed air, remove slag, dust and oil dirt, and avoid using liquid cleaning agent directly.
  • Manually trigger the switch repeatedly to test the reset performance; replace the switch if it cannot bounce back normally.
  • Inspect the signal wire along the drag chain, repair broken wires and tighten the aviation plug; polish the oxidized terminals.
  • Use the system IO monitoring interface to check whether the signal changes synchronously when triggering the switch, judge whether the switch or the control board is faulty.
  • Confirm the normally open / normally closed setting parameters on the control system, adjust to match the actual wiring of the switch.

 

 

Notes

  • Before inspection and maintenance, cut off the main power supply of the equipment to prevent accidental movement of the machine tool.
  • Do not adjust the limit position arbitrarily. Too large limit range will cause collision risk of the machine.
  • After replacement or debugging, test the positive and negative limit of each axis one by one to confirm that the alarm and release functions are normal.

Leave a Reply

Your email address will not be published. Required fields are marked *

FIBER LASER CUTTING MACHINE SUPPLIER

BaokunBaokun Laser is a top manufacturer of laser cutting equipment. Over the past 20 years, we've been supplying customers from more than 90 countries and regions. OEM ODM acceptable.

ENQUIRY NOW
Seraphinite AcceleratorOptimized by Seraphinite Accelerator
Turns on site high speed to be attractive for people and search engines.