Send us a Message

We're always here for you, tell us how can we help?

Rack & Pinion Failure Troubleshooting for Fiber Laser Cutting Machines

Nov 16, 2026

Introduction The rack and pinion is a key transmission component of fiber laser cutters, determining cutting accuracy and machine stability. Dust, heavy loads and poor lubrication often lead to failures. This guide lists common faults, causes, troubleshooting steps and maintenance advice.     Fault Symptoms Periodic grinding noise and noticeable jitter during cutting Unstable dimensional […]

Read More

Laser cutting machine limit switch failure

Nov 13, 2026

Symptoms The axis cannot move to the limit position, and the system pops up a limit alarm. No alarm is triggered even when the machine runs to the extreme position. The equipment stops suddenly during operation randomly, showing intermittent limit signal abnormality. After triggering the limit, the axis cannot be released and returned normally.   […]

Read More

Servo Motor & Drive Fault Troubleshooting

Nov 9, 2026

Symptom Axis jitter, abnormal noise during movement, axis stuck, servo alarm, positioning deviation, machine running out of sync.     Possible Causes Loose wiring or poor contact of servo power line, encoder cable. Servo driver overcurrent, overvoltage or overload protection triggered. Parameter mismatch between servo drive and motor. Mechanical resistance is too large, guide rail […]

Read More

Laser Source Abnormal Alarm Troubleshooting

Nov 6, 2026

Symptom Laser source alarm pops up, no laser output, intermittent light emission, laser power drops obviously, machine stops cutting suddenly.     Possible Causes Abnormal communication signal between laser source and control system. Over-temperature protection triggered due to poor heat dissipation of the laser source. Optical fiber damage, loose fiber connector or contaminated fiber end […]

Read More

Gas Supply System Troubleshooting for Laser Cutting Machine

Nov 2, 2026

Symptom Unstable cutting air pressure, pressure alarm, intermittent air output, no gas discharge, abnormally high gas consumption, and fluctuating cutting section quality.     Possible Causes Insufficient gas cylinder pressure, valves not fully opened, or improper switching of the cylinder manifold. Damaged pressure reducing valve, fatigued pressure regulating spring, resulting in continuous output pressure drift. […]

Read More

FIBER LASER CUTTING MACHINE SUPPLIER

BaokunBaokun Laser is a top manufacturer of laser cutting equipment. Over the past 20 years, we've been supplying customers from more than 90 countries and regions. OEM ODM acceptable.

ENQUIRY NOW